Electronics Forum | Thu Jun 04 11:23:44 EDT 1998 | Frank S
If you could measure and chart 3 variables in my process, what would they be? The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure 7"
Electronics Forum | Thu Dec 20 12:05:46 EST 2007 | realchunks
Not you Steven. Blanket comments like "Double pass printing for solder paste is not needed and will cause defects. Redesign your stencil thickness or aperture sizes, change your paste mesh size or type, go to 45 degree blades." are so way off base.
Electronics Forum | Thu Dec 20 10:15:09 EST 2007 | slthomas
Wow, Chunks, condescension becomes you. Not. I think that in this forum when someone mentions *stencil* printing and doesn't specify what material, we tend to gravitate towards a scenario that involves printing solder paste first, then adhesive. If
Electronics Forum | Wed Dec 19 16:53:41 EST 2007 | flipit
Double pass printing for solder paste is not needed and will cause defects. Redesign your stencil thickness or aperture sizes, change your paste mesh size or type, go to 45 degree blades.
Electronics Forum | Thu Dec 20 07:50:12 EST 2007 | realchunks
Good to know there are a few smart people left in this industry like Darby. I love how everyone assumes the original poster was only talking solder paste. We use screen printers for five different materials. Some of which we triple print by design
Electronics Forum | Wed Dec 19 18:41:33 EST 2007 | darby
You printer is not solely designed for printing solder paste. This is why some of the options you would never use for paste appear in the menu. You may actually be printing overlays or yes, even t-shirts. This is why you may want to flood/print, prin
Electronics Forum | Thu Jun 04 11:57:59 EDT 1998 | Pete M
Be more specific on your problems? | If you could measure and chart 3 variables in my process, what would they be? | The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. The
Electronics Forum | Thu Jun 04 15:41:07 EDT 1998 | Chrys
| If you could measure and chart 3 variables in my process, what would they be? | The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure
Electronics Forum | Fri Jun 05 13:06:14 EDT 1998 | Steve Schrader
| If you could measure and chart 3 variables in my process, what would they be? | The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure
Electronics Forum | Fri Apr 10 13:25:08 EDT 2009 | jefflkupkt
Layer 2 is the ground plane layer of a 4 layer board. After installing a 2.5 mm DC power jack and 0.1 center SIP header by hand, the ground pin disconnects and causes an open. My board supplier said they passed Electrical Test. Prepreg was within
.gif)
